Baldor TS250 User Manual Page 22
- Page / 88
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
3-10 Receiving & Installation MN2417
Post Installation Checks
Continued
16. Place the voltage output selector switch in the appropriate position.
17. Verify all loads are disconnected.
18. Verify the Master Control is in the “Stop” position.
Connect the engine starting battery to the starter. Verify it is installed correctly.
19. Verify the fuel source is available.
20. Remove all tools, rags, etc. from inside the generator enclosure. Close all enclosure
doors and be sure no hands are inside the generator enclosure when it starts.
21. Start the generator.
22. The engine should begin to crank and start when the fuel moves to the engine. If the
engine fails to start, refer to Section 5 Troubleshooting.
23. With the engine running, several checks must be made:
a. Verify there are no fuel leaks. If a fuel leak is detected, stop the engine (set the
Master Control in the “Stop” position) immediately and repair the leak before
proceeding.
b. Verify there are no coolant or oil leaks. If a leak is detected, stop the engine (set
the Master Control in the “Stop” position) immediately and repair the leak before
proceeding.
c. Verify that operation is smooth. If squeals, vibrations or other abnormal sources of
noise exist, stop the engine (set the Master Control in the “Stop” position)
immediately and repair before proceeding.
d. Verify the correct voltage exists at the receptacles.
WARNING: Engine coolant is under pressure and is near the boiling point of water when engine is hot.
Do not open the coolant system until the engine has completely cooled. Hot coolant can
cause severe burns and other injuries. When engine is cool, coolant level can be checked.
24. After the operation checks are made, stop the engine (set the Master Control in the
“Stop” position) and wait 2 hours for the engine to cool. When the engine is cool,
check engine oil and coolant levels as instructed in the engine operation manual.
25. Close all enclosure covers. The post installation checks are now complete.
- Tier 2/3 Towable Generators 1
- (Trailer and Skid Mounted) 1
- Table of Contents 3
- Section 1 5
- Product Safety Information 5
- IMPORTANT SAFETY INSTRUCTIONS 6
- Section 2 11
- General Information 11
- Section 3 13
- Receiving & Installation 13
- 10.85401--G10 14
- TA0000C10 14
- BA0236A00 14
- BA0236A02 14
- Continued 22
- Section 4 23
- Operation 23
- OFF MAN AUT 32
- Idle Function 37
- Stabil Time 37
- 4-16 Operation MN2417 38
- Table 4-10 Engine Setpoints 38
- Operation 4-17MN2417 39
- 4-18 Operation MN2417 40
- Operation 4-19MN2417 41
- 4-20 Operation MN2417 42
- Section 5 43
- Appendix A 47
- Wiring Diagrams 47
- A-2 Wiring Diagrams MN2417 48
- Wiring Diagrams A-3MN2417 49
- A-4 Wiring Diagrams MN2417 50
- Wiring Diagrams A-5MN2417 51
- A-6 Wiring Diagrams MN2417 52
- Wiring Diagrams A-7MN2417 53
- A-8 Wiring Diagrams MN2417 54
- Wiring Diagrams A-9MN2417 55
- A-10 Wiring Diagrams MN2417 56
- Wiring Diagrams A-11MN2417 57
- A-12 Wiring Diagrams MN2417 58
- Wiring Diagrams A-13MN2417 59
- A-14 Wiring Diagrams MN2417 60
- Wiring Diagrams A-15MN2417 61
- A-16 Wiring Diagrams MN2417 62
- Wiring Diagrams A-17MN2417 63
- A-18 Wiring Diagrams MN2417 64
- Wiring Diagrams A-19MN2417 65
- A-20 Wiring Diagrams MN2417 66
- Wiring Diagrams A-21MN2417 67
- A-22 Wiring Diagrams MN2417 68
- Wiring Diagrams A-23MN2417 69
- A-24 Wiring Diagrams MN2417 70
- Wiring Diagrams A-25MN2417 71
- A-26 Wiring Diagrams MN2417 72
- Wiring Diagrams A-27MN2417 73
- A-28 Wiring Diagrams MN2417 74
- Wiring Diagrams A-29MN2417 75
- A-30 Wiring Diagrams MN2417 76
- Wiring Diagrams A-31MN2417 77
- A-32 Wiring Diagrams MN2417 78
- Wiring Diagrams A-33MN2417 79
- A-34 Wiring Diagrams MN2417 80
- Wiring Diagrams A-35MN2417 81
- A-36 Wiring Diagrams MN2417 82
- Wiring Diagrams A-37MN2417 83
- A-38 Wiring Diagrams MN2417 84
- Wiring Diagrams A-39MN2417 85
- A-40 Wiring Diagrams MN2417 86
- Baldor District Offices 87
- © Baldor Electric Company 88
- Printed in USA 88
Related products and manuals for Generators Baldor TS250
Generators Baldor MN2412 User Manual
(32 pages)
(32 pages)
Generators Baldor PC32RI User Manual
(28 pages)
(28 pages)
Generators Baldor IDLC40-2J User Manual
(1 pages)
(1 pages)
Generators Baldor IDLC450-3D User Manual
(1 pages)
(1 pages)
Generators Baldor IDLC250-3J User Manual
(1 pages)
(1 pages)
© 2020, manymanuals.com. All rights reserved. | 1.120 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals