Baldor TS250 User Manual download pdf (Page 13)

Section 3

Receiving & Installation

Receiving & Installation 3-1MN2417

Receiving & Inspection When you receive your generator, there are several things you should do immediately.

1. Observe the condition of the shipping container and report any damage immediately to

the commercial carrier that delivered your system.

2. Verify that the part number of the system you received is the same as the part number

listed on your purchase order.

3. If the system is to be stored for several weeks before use, be sure that it is stored in a

location that conforms to published storage temperature and humidity specifications.

WARNING: Never stand under or close to an object that is being hoisted or lift into position. Accidents

happen and if the object falls or tips over you or someone else could be c rushed by the

weight of the object causing severe injury or death to to yourself or others. Always remain a

safe distance f rom the object and always wear protective head gear (hard hat).

Lifting the Generator When lift or hoist equipment is used to lift the generator and move it to position, be careful not

to contact overhead wires or other obstacles. Be sure the lift or hoist equipment has appropriate

capacity and tires for the terrain to avoid becoming stuck or tipping over. If the shipping pallet is intact,

use a fork lift to move the generator. If the shipping pallet has been removed, use the “Lift Point”

hole at the top of the generator, Figure 3-1.

The lift point is designed only for the weight of the generator and factory trailer. Do not lift by these

points if the generator is mounted to a trailer that has been modified from the factory specifications

for stock units. Please consult Baldor for custom designs.

Figure 3-1 Generator Lifting

Lift Point

Table 3-1 Mounting Dimensions

Generator No. of Axles A A1 A2 B B1 C C1

TS25 1 67 47.5 5.5 130 74 62 38

TS35 1 65 48.5 5.5 136.5 74 62 38

TS45 2 82 60 5.5 146 84 62 38

TS60 2 83.5 62.5 5.5 150 84 62 38

TS80 2 83.5 62.5 5.5 150 84 62 38

TS130 2 92.5 75 5.5 178 118 75 42

TS175 2 92.5 76 5.5 180 130 75 48

TS250 2 102 76 7 218 159 82 54

TS400 2 126 93 5.22 251 195 98 66

Physical Location The mounting location of the system is important. It should be installed in an area that is

protected from direct harmful gases or liquids, dust, metallic particles, shock and vibration.

It should be installed in an outdoor location so the exhaust fumes are vented to the atmosphere.

When the Generator is installed outdoors

The factory installed enclosure is designed to keep out undesirable weather elements while

providing cooling and ventilation.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 87 88

No comments

Baldor TS250 User Manual Page 13